Skip to main content
PartAndStock
Blog

What Is the MCP6002? Rail-to-Rail CMOS Op-Amp and Uses

November 16, 2026 4 min read
Quick answer

The MCP6002 is a rail-to-rail input/output (RRIO), low-power, CMOS dual op-amp. It runs from a single low-voltage supply (1.8–6 V) and its output reaches the rails; handy in 3.3V/5V circuits for driving full-scale signals into an ADC. Unlike the LM358 it reaches the output rails on a single supply. Its bandwidth is narrow (~1 MHz).

The MCP6002 is a rail-to-rail input/output (RRIO), low-power, CMOS dual op-amp. Because it runs from a single low-voltage supply and its output reaches the supply rails, it is very handy in modern 3.3 V/5 V circuits. For the concept, see what is an op-amp.

What is the MCP6002 used for?

Sensor signal amplification, buffers, active filters and low-power/battery analog circuits. Being rail-to-rail it overcomes the LM358's limit of not reaching the output rails on a single supply; from a single 3.3 V it can drive a full-scale signal into a microcontroller's ADC.

Specifications

ParameterValue
TypeDual CMOS op-amp (RRIO)
Bandwidth (GBW)~1 MHz
Supply1.8 – 6 V (single)
PowerLow consumption

Watch out

Its bandwidth is narrow (~1 MHz); high frequency/audio needs a faster op-amp. The CMOS input is high-impedance but noise/offset differ from precise bipolar types; for precise measurement types like the OP07 are better. The rail-to-rail "output" gets very close to the rails but a few mV of margin remains under load.

Equivalents

  • LMV358: low-voltage LM358 family (rail-to-rail output).
  • MCP6004: the quad-channel member of the family.
  • TLV2372: a similar rail-to-rail op-amp.

Find it in our catalog

Use the MCP6002 search.

Frequently Asked Questions

What is the MCP6002?+
The MCP6002 is a rail-to-rail input/output (RRIO), low-power, CMOS dual op-amp. It runs from a single low-voltage supply (1.8–6 V) and its output reaches the supply rails; it is handy in 3.3V/5V circuits.
What is the difference between the MCP6002 and the LM358?+
The MCP6002 is rail-to-rail and low-power CMOS; its output gets close to the supply rails. The LM358 cannot fully reach the output rails on a single supply. For low-voltage/ADC applications the MCP6002 is better.
What does rail-to-rail mean on the MCP6002?+
It means the input and output voltage range can get very close to the supply rails (0 V and VDD). This makes full-scale signal handling on a single supply easier.
What is an equivalent of the MCP6002?+
The low-voltage LMV358; the quad MCP6004; the similar rail-to-rail TLV2372.